11 After fitting the M14 cylinder head bolts 8 , tighten the M10 bolts to the specified torque {34 N·m (3.5 kgf·m) [25.1 lbf·ft]} in the sequence shown. 01945 Cylinder head gasket [Removal] 11 CAUTION When removing the cylinder head gasket 11, be careful not to scratch the cylinder head and valve assembly 10 and the crankcase * . [Fitting] Fit the cylinder head gasket 11 onto the crankcase * as shown. 13582 Push rod runout If any measurement exceeds the specified limit, replace the defective part(s). 12 01948 Tappet-to-crankcase clearance If any measurement exceeds the specified limit, replace the defective part(s). * 13 01949 11-15