Caterpillar — Caterpillar 99709-68120 — user manual

PISTONS, CONNECTING RODS, AND CYLINDER LINERS N Service procedure G Pre-disassembly inspection (1) Piston projection from crankcase top surface NOTE The piston projections affect engine performance and must therefore be checked. WARNING The cylinder liners may rise out of position when the crankcase is turned over or the crankshaft is turned. Hold their flanges down using bolts and washers A. 01985 Measure the projection of each piston at two points and calculate the average of the two values. A : Front of engine If the average value is out of specification, check the clearances between all relevant parts. 01986 (2) Connecting rod end play Measure the end play of every connecting rod.

If any measurement exceeds the specified limit, replace the defective part(s). 01987 (3) Cylinder liner flange projection If any measurement is out of specification, replace the defective part(s). B : Flange projection CAUTION If the cylinder liner 6 flange projection is insufficient, bearing pressure on the cylinder head gasket will be too low in the region of the bore, possibly causing gas to leak. 01988 11-30