PISTONS, CONNECTING RODS, AND CYLINDER LINERS [Installation] Align oil hole A in the connecting rod bushing 3 with oil hole B in the connecting rod 4 . Apply the Connecting Rod Bushing Puller to the connecting rod bushing 3 . Using a press, apply pressure of approximately 49 kN (5,000 kgf) [11,015 lbf] such that the bushing is pressed into the connecting rod 4 from the chamfered side C . NOTE After installing the connecting rod bushing 3, insert the piston pin 2 and check that it turns smoothly and without play. 13617 Piston pin, connecting rod, and piston [Removal] Tap out the piston pin 2 using a rod and hammer.
If the piston pin 2 is difficult to remove, heat the piston 8 in hot water or using a piston heater. 8 02022 [Installation] Apply engine oil to the piston pin 2 . With the connecting rod 4 and piston 8 aligned as illustrated, insert the piston pin to hold these components together. A : Weight mark B : Weight mark (A, B, C, D, E, F, G, H, I, V, W, X, Y, Z) C : Alignment mark for connecting rod cap : Front mark 02023 If the piston pin 2 is difficult to insert, heat the piston 4 in hot water or using a piston heater. CAUTION No piston should differ from any other piston by a weight of more than log. The connecting rods must all have the same weight mark.
After inserting the piston pin 2, check that it turns smoothly and without play. 11-38 2 4