Caterpillar — Caterpillar 99709-68120 — user manual

PISTONS, CONNECTING RODS, AND CYLINDER LINERS to Piston rings and piston Piston rings [Removal] 8 5 02024 [Installation] Fit the oil ring 7 onto the piston 8 with its side rail gaps A and the expander spring gap B in the positions illustrated. Fit the compression rings 5 , 6 onto the piston such that the manufacturer's marks C near the gaps face upward. Align the compression ring gaps D , E as illustrated. 02028 D : 1st compression ring gap E : 2nd compression ring gap : Front mark [Inspection] (1) Piston ring end gap Using the crown of a piston 8 , push the piston ring 5 , 6 or 7 horizontally into a cylinder liner F for measurement.

Taking care not to move the piston ring 5 , 6 or 7 , measure the end gap. Replace all the rings of a piston if any gap exceeds the specified limit. NOTE To keep the piston ring 5, 6 or 7 horizontal, be sure to insert them into the cylinder liner F using a piston 8. Push the piston ring 5, 6 or 7 down to the bottom of cylinder liner F; the bottom should be less worn than the top. Piston ring 5, 6 or 7 must be replaced as a set. Never replace piston rings individually. 02027 11-40