Caterpillar — Caterpillar 99709-68120 — user manual

11 No. 1 idler shaft and No. 1 idler gear bushing [Inspection] If the clearance exceeds the specified limit, replace the defective part(s). 3 2 02576 No. 1 idler gear bushing [Removal] A : Press 02577 [Installation] Using the Idler Gear Bushing Puller, press the No. 1 idler gear bushing 3 into the No. 1 idler gear 4 from the side of the gear whose internal diameter is chamfered B. A : Press After installation, measure the clearance again. If the measurement is below the nominal value range, ream the bushing 3 . 02578 Removing No. 1 idler shaft and No. 1 idler gear Loosen the bolt 1 by approximately 15 mm (0.591 in.), then remove the No. 1 idler shaft 2 and No.

1 idler gear 4 as a single unit. 4 2 02070 Installing No. 1 and No. 2 idler gears Fit the No. 1 and No. 2 idler gears 4 , 12 such that their alignment marks 1 2 3 4 ”) are aligned with those on the gears with which they mate. 12 4 *1 : Drive gear *2 : Camshaft gear *3 : Crankshaft gear 02074 11-51