TIMING GEARS No. 2 idler gear bushing and No. 2 idler shaft [Inspection] If the clearance exceeds the specified limit, replace the defective part(s). 13 11 02579 No. 2 idler gear bushing [Removal] A : Press 02580 [Installation] Using the Idler Gear Bushing Puller, press the No. 2 idler gear bushing 11 into the No. 2 idler gear 12 from the side of the gear whose internal diameter is chamfered B . A : Press After installation, measure the clearance again. If the measurement is below the nominal value range, ream the bushing 11 . 02581 Removing No. 2 idler shaft 13 02075 11-52