Caterpillar — Caterpillar 99709-68120 — user manual

11 Camshaft bushings Removal and installation of camshaft bushings should be carried out using the Camshaft Bushing Installer and Extractor. Each guide of the tool is stamped with an identification mark (“ 1 2 3 4 ”) in the position shown. Use correct adapter and/or guide piece to remove and install a bushing according to the table below. 13020 Camshaft Bushing Installer and Extractor> A : Rod B : Camshaft bushing adapter C : Guide piece D : Nut [Removal] Remove the No. 4 and No. 3 camshaft bushings 12 , 13 from the rear of the engine. Remove the No. 2 and No. 1 camshaft bushings 14 , 15 from the front of the engine. :

Camshaft Bushing Installer and Extractor 02094 [Installation] Identify the No. 1 to No. 4 camshaft bushings 12 to 15 from their identification marks (“ 1 2 3 4 ”) in accordance with the table below. If any bushing's identification mark is unclear, identify the bushing from its internal diameter E . 11741 11-59 Bushing No. (from front of engine) Identification mark No. 1 1 No. 2 2 No. 3 3 No. 4 4 Bushing No. (from front of engine) Identification mark Internal diameter [mm (in.)] No. 1 1 φ57.75 (φ2.27) No. 2 2 φ58.00 (φ2.28) No. 3 3 φ58.25 (φ2.29) No. 4 4 φ58.50 (φ2.30)