CAMSHAFT [Installation] Fit the camshaft gear 8 onto the camshaft 11 in the direction illustrated. Do not forget to fit the key 10 . 11714 Inspecting camshaft (1) Cam lift If any base circle-to-lobe height difference is less than the required value, replace the camshaft 11 . NOTE Since the cams are tapered, they must be measured at the position A shown in the diagram. 11 02090 B : Lobe height C : Base circle diameter D : Front of engine (2) Camshaft bend Support the camshaft 11 at its No. 1 journal E and No. 4 journal F , then take measurements at the No. 2 journal G and No. 3 journal H . If either measurement exceeds the specified limit, replace the camshaft.
NOTE Turn the camshaft 11 through one revolution. One-half of the dial indicator reading represents the camshaft's bend. 04108 to Camshaft and camshaft bushings [Inspection] If any clearance exceeds the specified limit, replace the defective part(s). NOTE Measure the camshaft bushings 12 to 15 with the camshaft installed in the crankcase * . 15 11 02093 11-58