Caterpillar — Caterpillar 99709-68120 — user manual

11 Fitting side cover Apply an even, unbroken bead of sealant A to the side cover 5 . Fit the side cover 5 onto the crankcase within 3 minutes of applying the sealant A . 5 CAUTION Ensure that the sealant application surface of the side cover 5 is clean before applying sealant. When fitting the side cover 5, hold it firmly in position to prevent spreading the sealant. After fitting the side cover 5, wait at least an hour before starting the engine. Apply a new bead of sealant A whenever the mounting bolts of the side cover 5 have been loosened. 18062 Camshaft assembly [Removal] When removing the camshaft assembly 6 , take off the side cover 5 and support the camshaft by hand.

Remove the bolts A from the camshaft gear holes, then slowly remove the camshaft assembly 6 . 6 CAUTION 02086 Take care not to damage the camshaft bushings 12 to 15 when removing the camshaft assembly 6. [Installation] Before installing the camshaft assembly 6 , measure the end play between the thrust plate 9 and camshaft 11 . If the measurement exceeds the specified limit, replace the defective part(s). With the alignment marks lined up on the camshaft gear 8 and No. 2 idler gear, fit the camshaft assembly. 02092 Camshaft gear [Removal] 8 CAUTION The camshaft gear 8 must be removed with the appropriate special tools. Do not tap off the camshaft gear since this would damage it. 02088 :

Gear Puller : Plug 11-57