11 N Service procedure G Pre-disassembly inspection Crankshaft assembly end play If the measurement exceeds the specified limit, replace the defective part(s). 02098 4 Torsional damper CAUTION Leakage of silicon oil from the caulked seam A can cause the viscous-type torsional damper to stop functioning. Note the following points: Check that the caulked seam is free of gouges and other damage. Do not submit the torsional damper to shock by striking it with a hammer or dropping it. Do not roll the torsional damper or stack it with other units.
14933 Installing front cover assembly Apply an even, unbroken bead of sealant A to the mating surface of the front cover assembly 5 to be mounted to the crankcase 18 . Fit the front cover assembly 5 onto the crankcase 18 within 3 minutes of applying the sealant A . 5 CAUTION Ensure that the sealant application surface of the front cover assembly 5 is clean before applying sealant. When fitting the front cover assembly 5, hold it firmly in position to prevent spreading the sealant. After fitting the front cover assembly 5, wait at least an hour before starting the engine. Apply a new bead of sealant A whenever the mounting bolt of the front cover assembly 5 have been loosened.
11729 Main bearings [Installation] Install the main bearings 9 , 17 such that their lugs A fit into the corresponding grooves. 17 9 CAUTION The upper main bearing 17 has an oil hole B. The lower main bearing 9 has no oil hole. Take care not to confuse the upper and lower parts. 11730 11-65