Caterpillar — Caterpillar 99709-68120 — user manual

CRANKSHAFT AND CRANKCASE [Inspection] CAUTION Do not attempt to manually expand either bearing 9, 17 if its span is insufficient. Upper and lower bearings 9, 17 must be replaced as a set. (1) Span when free If either bearing's span when free exceeds the specified limit, the bearings 9 , 17 must be replaced. (2) Main bearing-to-crankshaft clearance Fit the upper main bearing 17 into the crankcase 18 and the lower main bearing 9 into the main bearing cap 10 . Then, tighten the bolts 8 to their specified torque. Measure the internal diameters of the main bearings 9 , 17 and the outside diameter A of the crankshaft journal.

If the clearance exceeds the specified limit, replace the defective part(s). 01995 02104 Main bearing caps [Removal] 10 02100 [Installation] Starting at the front of the engine B , fit the main bearing caps 10 in the order of the numbers A embossed on them and such that the numbers are in the positions illustrated. The bolts 8 can be reused only three times. Before fitting the bolts, make a punch mark on the head of each bolt to indicate times of reuse. CAUTION If any bolt already has three punch marks, it must not be reused any more; replace it with a new one. 02103 11-66