11 Tighten the bolts 8 to the specified torque. Then, turn the bolts further in accordance with the following procedure: Turn the holder C of the Socket Wrench counter-clockwise to tension the built-in spring. D : Socket E : Rod F : Rod (extension) 01991 Set the socket wrench such that the built-in spring force forces the rod F against the crankshaft assembly 12 . On the holder C , select the inscribed line G that is easiest to see. Using the selected line as a reference, turn the socket D 90° clockwise. (One gradation on the scale H represents 5°.) CAUTION 12829 Since the bolts utilize the plastic region tightening method, they must not be tightened further after this procedure.
Installing thrust plates Fit a thrust plate 11 on each side of the main bearing caps 10 and at the rear end of the crankcase 18 such that the oil grooves A are on the outside. 11 B : Locating pin NOTE If oversize thrust plates 11 are used, they must be fitted on both sides of the bearing caps 10. Ensure that the bearing cap rear thrust plates and the rearmost thrust plate in the crankcase 18 are the same size. Note, however, that the front and rear thrust plates on each bearing cap may be of different sizes.
11731 Installing front oil seal slinger Using the Front Oil Seal Slinger Installer, drive the front oil seal slinger 13 onto the crankshaft 16 until the tool's end face A is pressed firmly against the guide B . 13 11969 11-67