Caterpillar — Caterpillar 99709-68120 — user manual

CRANKSHAFT AND CRANKCASE Installing rear oil seal slinger Using the Rear Oil Seal Slinger Installer, drive the rear oil seal slinger 14 onto the crankshaft 16 until it is pressed firmly against the end face A of the crankshaft gear 15 . 14 02063 Removing and fitting crankshaft gear [Removal] 15 CAUTION Do not tap off the crankshaft gear 15 since this could damage it. 02110 : Gear Puller [Installation] Using a piston heater or the like, heat the crankshaft gear 15 to a temperature of approximately 100°C (212°F). Align the locating pin A on the crankshaft 16 with the notch B in the crankshaft gear 15 . Then, drive the gear into position by striking its end face with a plastic mallet.

02111 Crankshaft [Inspection] (1) Roundness and cylindricity of crankshaft journal and pin If either measurement exceeds the specified limit, replace the crankshaft 16 or grind it to undersize. 16 02105 (2) Bend Support the crankshaft 16 at its No. 1 journal A and No. 7 journal B. Measure the extent of bending in the crankshaft at the centre of the No. 4 journal C . If the measurement exceeds the specified limit, replace the crankshaft. NOTE With the dial indicator applied to the centre journal, turn the crankshaft 16 through one revolution. One-half of the dial indicator reading represents the extent of bending. 04110 11-68