11 [Rectification] NOTE If the crankshaft 16 is rectified by grinding, the main bearings 9, 17 must be replaced with undersized ones. Grind such that the centre-to-centre distance F between the journal D and pin E does not change. F : 57.5 mm (2.26 in.) Grind such that the journal width G and pin width H do not change. G : 37 mm (1.46 in.) H : 42 mm (1.65 in.) Finish the corner fillet smoothly and to the specified radius J . J : Radius 4 ± 0.2 mm (Radius 0.157 ± 0.008 in.) Carry out a magnetic inspection to check for cracks caused by grinding. Also, check that the Shore hardness of the surface has not dropped below Hs 75.
+ 0.001 0.003 + 0.025 0.075 02107 + 0.008 0 + 0.2 0 Crankshaft undersize dimensions Unit: mm (in.) 11-69 Degree of undersize 0.25 (0.00984) 0.50 (0.0197) 0.75 (0.0295) 1.00 (0.0394) Finished journal diameter 79.685 to 79.705 (3.137 to 3.138) 79.435 to 79.455 (3.127 to 2.537) 79.185 to 79.205 (3.117 to 3.118) 78.935 to 78.955 (3.107 to 3.108) Finished pin diameter 64.67 to 64.69 (2.546 to 2.547) 64.42 to 64.44 (2.536 to 2.537) 64.17 to 64.19 (2.526 to 2.527) 63.92 to 63.94 (2.516 to 2.517) Roundness 0.01 (0.000394) or less Cylindricity 0.006 (0.000236) or less • When grinding K, turn the crankshaft 16 counter-clockwise as viewed from its front end.
The grinder L should rotate in the same direction. • When finishing N the crankshaft 16 with sandpaper or a whetstone M, rotate the crankshaft clockwise. 02108 18 Distortion of crankcase top surface If distortion exceeds the specified limit, correct it with a surface grinder. A: Measurement positions CAUTION When grinding the crankcase 18, take care that the piston projections stay within specification. 02114