John Deere OMAL171363 (7430 and 7530) — AutoPowr Operation

Operating the Tractor AutoPowr AutoPowr — Cold Weather Starting To avoid damage at temperatures below freezing, an automatic function prevents the drive system from engaging too soon. After the engine is started, diagnostic trouble code UIC 305057.01 (INFORMATION FOR OPERATOR: Transmission Warm-up Routine is Active) appears on the display. LX1026066 —UN—10MAY01 The warm-up routine can only be started if the reverser lever is in the "corner park" position. If the reverser lever is in any position other than park, code UIC 305058.01 (INFORMATION FOR OPERATOR: Transmission Warm-up Routine Cannot be Activated, Park must be Engaged) is displayed.

The time required for the transmission to warm up will vary depending on temperature: Temperature range Warm-up time above -7° C (19.4° F) none LX1037175 —UN—06JUN06 between -8° C (17.6° F) and -15° C (5° F) 96 seconds between -16° C (3.2° F) and -20° C (-4° F) 156 seconds between -21° C (-5.8° F) and -30° C (-22° F) 246 seconds At temperatures below -30° C (-22° F) only the transmission input shaft is turned. The warm-up routine starts as soon as the transmission oil temperature has reached -30° C (-22° F). NOTE: Engine speed may rise up to 1500 rpm during the warm-up routine.

OULXE59,001083F -19-09NOV05-1/1 AutoPowr Operation Reverser lever To drive the tractor, move the lever to forward (B) or reverse (D). If the lever is moved from forward or reverse back to the center park position (F), the tractor will continue to roll and the transmission goes to its “Power Zero” mode. Ten seconds after the tractor stops rolling, park will automatically engage. If the lever is moved from forward or reverse directly to the corner park position (E), the tractor will brake to a stop using the transmission. Park will then engage. Remember to actuate the brake pedals as well when driving downhill.

LX1037182 —UN—06JUN06 If the lever is moved from forward or reverse to the "Power Zero" position (C), the tractor will continue to roll but it will not be braked by the transmission. When the tractor is stationary, power remains at the transmission. For “Power Zero”, the lever must be held firmly in this position. If the lever is released from the “Power Zero” position, it will automatically go to the center park position (F). A—Neutral B—Forward C—“Power Zero” D—Reverse E—Corner park F—Center park the direction clutches are opened and there will be no power in the transmission. The tractor may roll away. When the tractor is stopped, move the lever back to the corner park position.

If the lever is moved to neutral (A), Continued on next page OULXE59,0010840 -19-27APR06-1/4 48-2 030612 PN=106