Operating the Tractor AutoPowr Speed control lever Travel speed is regulated using the speed control lever. Two speed ranges are available. Speed range 1 allows a maximum forward speed of 20 km/h (12.4 mph). Speed range 2 allows a maximum forward speed of 40 km/h (25 mph) or 50 km/h (31 mph). The maximum speed in range 1 is always the minimum speed in range 2. This implies that speed does not change when the range is changed. LX1037183 —UN—10OCT05 The maximum speed in a speed range is adjusted using speed wheel (B). See “AutoPowr Settings” on the following pages for details.
The maximum speed of a range is reached with the engine at full throttle and the speed control lever at the end of its travel in the speed range (provided tire dimension match the set values precisely). If the accelerator pedal is not at the end of its travel, the tractor will move at a corresponding speed (not proportional). If the speed control lever is not at the end of its travel in a speed range, the tractor will similarly operate at a corresponding speed. A—Speed control lever B—Speed wheel (for setting maximum speed) 1— Speed range 1 2— Speed range 2 the minimum speed. For example, if a maximum speed of 0.50 km/h (0.33 mph) is set in range 1, the minimum speed is 0.20 km/h (0.12 mph).
Speed wheel (B) does not have a stop and can be “infinitely” adjusted. It makes a change in relation to the previous setting. If the maximum speed setting is changed with wheel (B) while the tractor is moving, the change is always based on the last setting. Turning the wheel will directly increase or decrease the last maximum speed setting. Any changes are stored by the tractor's electronics. At speeds below 0.6 km/h (0.37 mph), changing engine speed does not have any effect on travel speed. The following occurs if the speed-adjusting wheel is used to increase travel speed while the tractor is in motion in range 2 with creeper mode selected:
If the speed selected is below 10 km/h (6.2 mph), the transmission remains in creeper mode. This means the originally set values will apply on changing back to range 1. Speed range 1 will flash on the digital display. Creeper mode also remains in effect if the 10 km/h (6.2 mph) speed is temporarily exceeded and then reduced to under 10 km/h (6.2 mph) before returning to range 1. Creeper mode will be exited if the 10 km/h (6.2 mph) speed is exceeded and range 1 is re-engaged. Forward speed range 1 will be automatically adjusted (to 2 km/h; 1.24 mph). Creeper If a forward travel speed below 2 km/h (1.24 mph) is used in speed range 1, the tractor will automatically shift to creeper mode.
The possible minimum travel speed is 0.05 km/h (0.03 mph). The maximum speed in range 2 is 2.5 times higher than in range 1. In both speed ranges, maximum speed in creeper mode is not more than 2.5 times higher than Continued on next page OULXE59,0010840 -19-27APR06-2/4 48-3 030612 PN=107