John Deere OMAL171363 (7430 and 7530) — AutoPowr Operation

Operating the Tractor AutoPowr Accelerator pedal and hand throttle The stronger signal is always used for transmission control. If the accelerator pedal or hand throttle are moved to command a higher engine speed, engine speed increases. In Eco mode, once the set travel speed is reached, engine speed is reduced (load controlled). LX1037184 —UN—10OCT05 If the reverser lever is in forward or reverse, the tractor can be accelerated to the set speed using the accelerator pedal or hand throttle. The immediate travel speed is directly dependent on the setting of the accelerator pedal or hand throttle. Engine speed is indirectly determined by the position of the accelerator pedal.

When the accelerator pedal or hand throttle are actuated, the values set in the CommandCenter for automatic control and engine-speed limitation are always taken into account. For example, the value set for engine-speed limitation is not exceeded, even at full throttle. In Eco A—Hand throttle mode, the engine turns only as fast as needed, even if the operator applies full throttle. OULXE59,0010840 -19-27APR06-3/4 Brake pedals If when driving the tractor both brake pedals are depressed, the tractor's speed will be reduced until it stops. Thanks to the automatic clutch function, there is no need to depress the clutch pedal when braking.

When the brakes are released again, the tractor automatically accelerates up to the speed currently commanded by the hand throttle or accelerator pedal. LX1024390 —UN—03JUL00 The higher the engine speed, the greater is the force required at the brake pedals to stop the tractor. A—Brake pedals Clutch pedal The clutch pedal normally does not need to be depressed to stop the tractor. If the clutch pedal is depressed, the corresponding clutch signal has priority over other commands. OULXE59,0010840 -19-27APR06-4/4 48-4 030612 PN=108