John Deere OMAL171363 (7430 and 7530) — AutoPowr — Settings

Operating the Tractor AutoPowr Setting the transmission's automatic control Press transmission button (A). The screen shown controls the extent to which the transmission is controlled automatically. When cell (B) is activated, fully automatic comes into force. The electronic system reacts automatically to the demands made on the engine by the PTO, hitch, electronic SCVs and steering brake. For more details, see Setting for fully automatic on the following pages. LX1037622 —UN—06NOV06 When cell (B) is de-activated, the following applies per the setting in cell (C): In setting 0 (manual), the only automatic intervention is to prevent the engine from stalling.

In setting 1, transmission control is minimally influenced by the electronic system. In setting 5, transmission control is most influenced by the electronic system. The extent of transmission automation progressively increases in settings 1 to 3, between 3 and 5 there is additional automation of engine control. LX1037629 —UN—31MAY06 Engine load control is set in settings 1 to 3. In settings from greater than 3 to 5 (Eco mode), the engine turns only as fast as needed. This results in fuel savings and noise reduction.

If the operator sets a specific engine speed in Eco mode and the electronic control system recognizes that this speed is not necessary, engine speed will be automatically reduced to a level adequate for tractor operation. Travel speed remains constant, however. Eco mode is not suited for lifting operations (where engine speed determines hydraulic pump output) and PTO operation (where engine speed directly determines PTO speed). A—Transmission Button B—Fully Automatic on/off C—Degree of Automation D—Next Page Setting 0 Manual transmission control Setting 1 Approx. 30% engine load control before transmission intervenes, i.e. the transmission ratio changes.

In Eco mode, you can override the set engine speed by operating the accelerator pedal and hand throttle at the same time. Setting 2 Approx. 18% engine load control before transmission intervenes. Setting 3 Approx. 4% engine load control before transmission intervenes. Setting 4 Approx. 16% engine load control* before transmission intervenes. Engine speed can be reduced electronically to a speed not lower than 1500 rpm in the partial load range. Setting 5 Approx. 16% engine load control before transmission intervenes. Engine speed can be reduced electronically to a speed not lower than 1200 rpm in the partial load range.

* If Intelligent Power Management (power boost) is activated (see Operating the Engine section), engine load control lies between 13% and 16%, depending on travel speed. Continued on next page OU12401,0001971 -19-25MAY10-2/7 48-6 030612 PN=110