John Deere OMAL171363 (7430 and 7530) — AutoPowr — Settings

Operating the Tractor AutoPowr The following list shows which automation settings are suitable for various types of tasks. Range A PTO operation Range B Towing operations with hydraulic power requirements Range C Any towing operation (field or road) without any hydraulic power requirement (since hydraulic power is not sufficient at an engine speed of 1200 rpm) LX1037190 —UN—11OCT05 Range D PTO operation, with precise PTO speeds (for example, when using a manure spreader) Range E Operation of balers Range F Tillage Range G Operation of mowers Range H Other operations requiring hydraulic power (e.g.

use of front loaders) Setting 1-2 Work in which the engine's flywheel mass (PTO operation) and vehicle inertia (earth-moving) are adequate to meet transient peaks in the power requirements (caused by the implement or task in hand). The following may be regarded as basic settings: Setting 2.5 Operations where engine speed is important. Setting 5 Operations where engine speed is not important. Procedure Setting for automatic Comment Summary of different types of work Crop protection, liquid fertilizer 1 The transmission behaves like a conventional one with stepped gears. As engine speed drops due to increased load, travel speed also drops.

The simultaneous reduction in PTO speed causes the output of pesticide to drop in step with travel speed. Adjust and operate pesticide equipment in accordance with the manufacturer's guidelines and the instructions provided by the pesticide/fertilizer producer. The less the engine is subjected to load control (e.g. 5 %), the greater the danger of excessive pesticide being metered as a result of the stepless change in the transmission ratio as load increases while engine and PTO speeds remain constant. Select other settings between 1 and 3, but take into account the technical aspects of the pesticide machine (metering, electronic regulation).

The user must ensure that the pesticide is metered correctly. Fertilizing (spreader for mineral-based fertilizers; manure spreader, liquid fertilizer) 3 A constant width of spray can be achieved only if PTO speed remains constant. If metering is not achieved on the basis of distance travelled, preselect a travel speed that can be sustained over the entire field. If the spreader functions independently of engine speed (e.g. a hydraulically-driven spreader), a different engine load control setting may be selected, provided the user makes sure that the material being sprayed is metered and distributed correctly.

Balers (large, round and high-pressure) 2-3 Select travel speed and engine load control so that the engine can cope with differences in terrain and windrow, to overcome load peaks with rising engine torque and the inertia of the driveline. PTO speed must be kept high enough for the machine to work properly. The operator may vary travel speed infinitely at any time as he pleases, without changing the engine speed, and thus adapt his speed to the requirements. Mowers, mowers with conditioners, self-loading wagons 2-3 Same as for balers. Turning, making and spreading windrows 1-3 Select a setting appropriate to your requirements.

PTO-driven tillage equipment (rotary harrow, rotary cultivator, tined rotor, also in combination with seed drills and spacing seeders) 2-3 Drive in a manner appropriate to the terrain, soil conditions and desired results. To achieve the desired crumb structure, there should not be too great an imbalance between PTO speed and travel speed. Mechanical drills (metered via a wheel on the ground, with no PTO-assisted tillage) greater than 3-5 Select a setting greater than 3 for economical driving. Pneumatic drills and spacing seeders (without tillage) 2-3 PTO speed must be sufficiently high for pneumatic distribution of the seeds.

Continued on next page OU12401,0001971 -19-25MAY10-3/7 48-7 030612 PN=111