John Deere OMAL171363 (7430 and 7530) — Adjust for Vertical Float

Hitch Lift Links A greater transport clearance is obtained by shortening the links. Extra working depth is obtained by lengthening the links. To level implement from side-to-side, adjust one link. Use handle (A) to adjust the link. Do this by lifting handle (A) out of lock (B) and setting the lift link to the length desired. After adjustment is completed, push handle (A) down and secure it with lock (B). LX1036473 —UN—24APR06 To adjust left lift link: If equipped with an adjusting handle, proceed in the same way as for the right link. If not equipped with an adjusting handle, remove the lift link from the draft link and screw yoke end (C) of lift link in or out.

Length (D) of links must be kept within the limits stated. A groove in the thread of each lift link indicates the maximum permitted setting. The threads must not be unscrewed any further out of the receiver. Minimum length 875 mm (34.4 in.) Maximum length 1035 mm (40.7 in.) LX1035442 —UN—13JAN05 NOTE: The lift link dimensions quoted above are with lift links locked in draft links (no vertical float). NOTE: A short lift link provides a short lifting height and maximum lifting force. A long lift link provides a long lifting height and less lifting force. LX1035443 —UN—13JAN05 IMPORTANT: When engaging the lift links in the lift arms, make sure that stops (E) are always at the rear as shown.

A—Adjusting Handle B—Lock C—Yoke End D—Length of Links E—Stops (2 on Each Lift Link) LX1049744 —UN—03MAY10 OU12401,00015B5 -19-30APR10-1/1 50-15 030612 PN=129