John Deere OMAL171363 (7430 and 7530) — Requirements for AutoPowr

TIA Tractor-Implement Automation Requirements for E-SCVs/E-ICVs The implement can move the SCVs in all of their 4 positions (retract, extend, neutral, and float). The implement can change the maximum flow of the SCVs up to the limit set by the operator. Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in the operator's manual of the implement. Transfer control using the hot key. NOTE: The operator sets the limit in the CommandCenter of the tractor; this limit set by the operator cannot be exceeded by the implement. To withdraw control: Actuate control lever of the corresponding SCV. Lock SCVs (transport lock).

Actuate remote control switch on the fender. To transfer control to the implement, the following preconditions have to be met: Operator sitting on seat. No malfunctions present at the SCVs. Control levers of SCVs are in their neutral positions. SCVs are not locked (transport lock). NOTE: If the implement is not authorized to change oil flow when the tractor is stationary, it will be prevented by the tractor. However, it is allowed to shut off the oil flow. OU12401,0001CD2 -19-11NOV09-1/1 Requirements for AutoPowr The implement can accelerate the tractor up to the limit set by the operator. The implement can stop the tractor.

It can start to drive the tractor again, with the approval of the operator. NOTE: The limit is determined by the maximum speed setting and the position of the speed control lever; this limit set by the operator cannot be exceeded by the implement. LX1037182 —UN—06JUN06 To transfer control to the implement, the following preconditions have to be met: Operator sitting on seat. No malfunctions present at the AutoPowr. Reverser lever must be in center park, power zero position, or forward position.

A—Neutral B—Forward C—Power zero position D—Reverse E—Corner park F—Center park Before transferring control to the implement, perform all necessary steps to prepare the implement as indicated in the operator's manual of the implement. Transfer control using the hot key. Increasing the speed if the implement commands stopping the tractor will end the travel speed Auto Mode. Increasing the speed can end the Auto Mode. The implement has all information to inform the operator that this intervention will end the travel speed Auto Mode (see operator's manual of the implement). Approval to start driving the tractor again after stopping:

Move reverser lever from center park via power zero to forward position. Actuate clutch pedal or brake pedal while the tractor rolls to a stop and hold the pedal while the tractor is stationary. Releasing the pedal causes the tractor to start moving. NOTE: Reducing the speed is always allowed. It is allowed to increase the limit set by the operator within 2 seconds after starting the travel speed Auto Mode. To withdraw control using the reverser lever: During driving: Move lever out of forward position. During stopping: Move lever to reverse position, neutral position or corner park position. The current travel speed can be limited by other processes (e.g. HMS).

This limit will be observed, however, it will not be considered as an intervention by the operator. To withdraw control using the speed control lever or the speed wheel: OU12401,0001CD3 -19-11NOV09-1/1 52-2 030612 PN=145