John Deere OMAL171363 (7430 and 7530) — Front PTO

Power Take-Off Operating Instructions LX1049749 —UN—21MAY10 LX1049900 —UN—22FEB11 Articulation on drive shaft Align forks correctly 1— Z-shaped layout 2— W-shaped layout As far as possible, angles (a) and (b) at the universal joints should be the same at both ends of the drive shaft. prescribed amount of overlap when shaped pipes are pushed together. In applications where this is not the case (e.g. sharp turns with PTO engaged), it is recommended to use a continuous-velocity drive shaft. IMPORTANT: Before using a PTO-driven implement, take action to ensure that the drive shaft is lubricated regularly. Comply with instructions in the Operator's Manual provided by the manufacturer. NOTE:

The two schematic drawings do not show any guards on the drive shaft. A guard is mandatory when using drive shafts. IMPORTANT: On multi-component, telescopic drive shafts, the yokes at each end must be aligned as shown. The yokes at each end must NOT be at 90° to one another (see arrows in illustration on the right). IMPORTANT: Only operating conditions described in the Operator's Manuals of the various implements are permitted. This applies particularly to maximum permissible angle of articulation, to the use of freewheel clutches and overload clutches, and to the OULXBER,00018EA -19-15FEB11-1/1 PTO Options IMPORTANT:

Implements may be driven at 540 rpm only if their power input never exceeds 70 kW (95 hp). Shiftable PTO for 540/540E/1000 rpm Shiftable PTO for 540E/1000/1000E rpm 1000 rpm front PTO The tractor may be equipped with one of the following PTO versions: OU12401,0001BA7 -19-08MAY09-1/1 PTO Speeds The engine speeds at which standard PTO speeds are achieved are listed under ”Engine” in the ”Specifications” section. OU12401,00014A0 -19-29JUN06-1/1 55-2 030612 PN=147