Ballast Selecting Ballast without special equipment, attachments, trailer or ballast, but with hydraulic oil and lubricants, a full fuel tank and an operator weighing 75 kg. CAUTION: When determining front and rear axle ballast, ensure that permissible axle loads and the maximum permissible machine weight (including mounted implements) are not exceeded (see Specifications). CAUTION: Use suitable lifting tackle/hoists when handling weights. Comply with local regulations regarding installation and maximum permissible number of weights. In order to maintain steerability, at least 20% of unladen mass must be on the front axle.
Unladen mass is the mass of the tractor Safety and performance of your tractor depend on correct ballasting of front axle (front weights) and rear axle (wheel weights, filling tires with liquid ballast, pick-up weight). OU12401,0001AA7 -19-17SEP08-1/1 Ballasting Rear Wheels Rear wheel ballast should be chosen so as to give 10 to 15% wheel slippage when operating. Field tests have shown that maximum horsepower available at the drawbar occurs in this range. Increased tire wear High fuel consumption Too much ballast leads to:
Increased load and thereby loss of power Overloading of tires and gearbox Soil compaction High fuel consumption Rear wheel ballast should never be such that the engine cannot be fully loaded at rated engine speed while the tractor is moving at 7 km/h (4.3 mph). If the engine labors or stalls below 7 km/h (4.3 mph), there is too much ballast on the rear wheels. NOTE: Do not use more than 3 weights on each rear wheel. Comply with the legal limits on tractor width. Too little ballast leads to: Excessive wheel spin and thereby loss of power OU12401,0000CBE -19-02JAN03-1/1 Measuring Rear Wheel Slip 1. Mark tire (A). 2. Mark starting point on the ground (B). 3.
Drive tractor forward with implement lowered until ten revolutions of the rear wheel have been made (C). 4. Again place a marker on the ground (D). 5. Now raise implement and again drive between the two markers on the ground. Note number of revolutions made between the two markers (E). LX000402 —UN—15AUG94 The number of revolutions gives the following percentage of wheel slip: 10.0 revolutions = 0% wheel spin 9.5 revolutions = 5% wheel spin 9.0 revolutions = 10% wheel spin 8.5 revolutions = 15% wheel spin 8.0 revolutions = 20% wheel spin 7.5 revolutions = 25% wheel spin 7.0 revolutions = 30% wheel spin LX,OSPU 000247 -19-01APR92-1/1 60-1 030612 PN=153