Ballast Installing Weights on Flanged Axle CAUTION: When installing and removing weights, always position wheels so that retainer jaws are at the top. This prevents weights from falling down. LX1031685 —UN—03APR03 Attach first weight to wheel dish using three cap screws (A). Tighten screws (A) to 305 N·m (225 lb.-ft.). When installing further weights, always position wheel so that retainer jaws (B) are at the top. Position additional weight in retainer jaws on top and screw it onto the existing weight with a cap screw (C) at the bottom. Tighten screw (C) to 215 N·m (159 lb.-ft.). IMPORTANT: After the first drive with wheel weights, retighten the screws.
Then, check the screws at the same interval as the wheel bolts. LX1031686 —UN—03APR03 OU12401,0000CFB -19-16FEB11-1/1 Filling Tires With Liquid Ballast To fill a tire, jack up the wheel and turn it so that the tire valve is at the top. Remove the valve insert and screw water valve onto valve stem. While the water is entering, air escapes through lateral bore in water valve. Stop filling tire when water drains from vent hole of valve. Filling a tire takes 15 to 30 minutes, depending on tire size. Then screw in air valve and pump up tire to the normal inflation pressure. The quantity of liquid ballast required varies depending on tire size and type.
If in doubt, consult your John Deere dealer or tire manufacturer. LX009450 —UN—03JAN95 If low temperatures are expected, an anti-freeze solution should be used. Tire manufacturers recommend a mixture of water and calcium chloride. This solution produces an increase in weight of 120 kg (269 lb). Add calcium chloride to the water - not vice versa. Do not fill radiator with this anti-freeze solution. The anti-freeze solution may be sucked from an elevated tank. To speed up the filling operation, a pump may be used (flush pump with clear water afterwards). To provide protection down to -25°C (-13°F), dissolve 34 kg (75 lb) of calcium chloride in 86 liters (22.7 U.S.
gal.) of water to obtain 100 liters (26.4 U.S. gal.) of anti-freeze solution. NOTE: On tractors with 50 km/h (31 mph) transmissions, filling tires with liquid ballast is NOT recommended. LX,OSPU 000250 -19-01MAR00-1/1 60-2 030612 PN=154