Ballast Draining the Tires Jack up wheel. Remove air valve and allow water to drain out. To clear the remainder of the water from the tire, insert the drain tube with the hose extension and pump air into the tire. The air pressure will push the remaining water out of the tire. LX009451 —UN—03JAN95 LX,OSPU 000251 -19-01OCT94-1/1 Pre-Assembling the Pick-Up Weight CAUTION: When performing the work described below, comply with the safety instructions. CAUTION: Equipment used to raise and transport the weight must be capable of bearing at least 900 kg (1985 lb) or 1150 kg (2535 lb). LX013997 —UN—02APR96 CAUTION: Use approved lifting equipment only. CAUTION: Observe safety rules.
Do not stand under suspended loads. NOTE: To facilitate the transport of the weight, it is a good idea to pre-assemble it on a pallet. Make sure the bearing weight of the pallet is sufficient. Arrange the side weights (B) alongside the center weight and install bearing shaft (C). Tighten nuts (D) to 300 Nm (220 lb-ft). If attaching to a three-point hitch, adjust pins (E) to their maximum lengths. Use a hoist to lower the center weight (A) onto a level surface. OULXE59,0010880 -19-16APR06-1/4 If attaching the center weight only, install a spacer bushing (A) at each end of the bearing shaft. Tighten the nuts to 300 Nm (220 lb-ft).
LX013999 —UN—02APR96 Continued on next page OULXE59,0010880 -19-16APR06-2/4 60-3 030612 PN=155