John Deere OMAL171363 (7430 and 7530) — Attaching to Three-Point Hitch (Front-End Attachment)

Ballast CAUTION: Keep the pick-up weight suspended until the retaining screw has been screwed in fully and is seated tightly. Also make sure that retaining nut (A) is in contact with the basic weight. Tighten the screw to 300 Nm (220 lb-ft). LX013465 —UN—03APR96 Now disengage the draft links and screw in the weight receiving pin as far as it will go. OU12401,0001CE1 -19-21SEP09-2/3 The pick-up weight may be attached using a crane or suitable hoist. Suspend the weight by the cast eyelet. Once the weight is located on the basic weight, install the retaining screw. Do not disengage the hoist until the screw is installed. LX1038314 —UN—18MAY06 Tighten the retaining screw to 300 Nm (220 lb-ft).

CAUTION: Keep the pick-up weight suspended until the retaining screw has been screwed in fully and the retaining nut is in contact with the basic weight. CAUTION: When using commercially available lifting equipment, make sure that its bearing capacity is sufficient. CAUTION: Use approved lifting equipment only. OU12401,0001CE1 -19-21SEP09-3/3 60-7 030612 PN=159