John Deere OMAL171363 (7430 and 7530) — Adjust Toe-In (Tractors with Front-Wheel Drive Axle)

Wheels, Tires Check Front Wheel Toe-In 1. Make sure tires are in the straight forward position by driving tractor in a straight line for approx. 15 m (50 ft). CAUTION: Keep the engine switched off while making the measurements, and secure the tractor so that it cannot roll away. LX1049286 —UN—08JUN10 2. First, put marks (+) at axle height on the front (1) of each of the two front wheels. 3. At the front, measure distance (1) from the edge of the right rim to the edge of the left rim, and make a note of this measurement. 4. Roll the tractor forward by half the circumference of the front wheel, bringing the (+) mark to the rear (2). 5.

At the rear, measure distance (2) from the edge of the right rim to the edge of the left rim, and make a note of this measurement. LX1049288 —UN—08JUN10 Dimension (1) at the front must correspond to dimension (2) at the rear. A deviation of ± 1.5 mm is permissible. OULXBER,00018ED -19-14JUN10-1/1 Adjust Toe-In (Tractors with Front-Wheel Drive Axle) 1. Align front wheels for travelling straight ahead, shut off the engine, move the transmission to park position and remove the ignition key. LX1029216 —UN—02APR03 2. Loosen locknut (A). NOTE: Toe-in of ± 1.5 mm (0.06 in.) is permissible. See Check Toe-In in this section.

Specification Maximum toe-in or toe-out—Clearance...................................................................... 1.5 mm (0.06 in.) 3. Turn rod (B) to obtain desired toe-in or toe-out. A—Locknut B—Rod 4. Tighten locknut (A) to specified torque. Specification Locknut—Torque...............................................................328 to 363 Nm 242 to 267 lb.-ft. OULXBER,0001918 -19-15SEP10-1/1 65-2 030612 PN=163