Additional Equipment — Hydraulic System Selective Control Valves The tractor may be equipped with four different types of selective control valves: 100 series, 200 series, 300 series or 350 series. 100 Series control valves provide the functions Raise and Lower plus a Float Position. LX1037195 —UN—17MAY06 Besides these functions, 200 Series control valves provide a lock function (A) which holds the control lever in the Raise or Lower position until it is moved manually. 300 and 350 Series control valves also have an additional lock function (B), which holds the control lever in the Raise or Lower position until the pressure in the oil circuit has reached a predetermined value (e.g.
when the remote control cylinder has reached its end position). A—Lock function 1 B—Lock function 2 C—No lock function Neither locking function is activated in position (C). The control lever returns to neutral as soon as it is released. loss of pressure caused by leakage (e.g. retracting cylinder) when the engine is shut off. On 350 Series selective control valves, the likelihood of leakage is further diminished. 100 Series selective control valves are NOT equipped with such a valve. If an implement (e.g. hydraulic cylinder) is connected, pressure connection (e.g. extending cylinder) has to be connected to the lower coupler.
With 200 and 300 Series selective control valves, a valve prevents sudden OU12401,0001B5F -19-11FEB09-1/1 Adjustment of Pressure Limit at Series 300 and 350 Selective Control Valves NOTE: All selective control valves are factory adjusted to 18000 kPa (180 bar; 2610 psi). If the selective control valve in lock function switches off too early (control lever goes to neutral too early), or if it switches off too late or not at all (lever goes to neutral too late or not at all), proceed as follows: LX1037196 —UN—17MAY06 1. If equipped, disconnect hydraulic hoses at the connectors. 2.
Engage the locking function (A) (as far as it will go to the right) and move flow control valve (B) to the mid-position. A—Lock function B—Flow control valve C—Plug 3. Take out plug (C) and insert a 1.5 mm (0.06 in.) hex. socket key. 4. Start the engine and turn the screw clockwise as far as it will go. NOTE: One full turn changes the pressure by approx. 2000 kPa (20 bar; 290 psi). 5. Move SCV control lever to the raise or lower position (the control lever remains in the raise or lower position). 7. Re-install the plug. 6. Turn the screw counter-clockwise until the control lever returns to neutral. OU12401,0001B60 -19-11FEB09-1/1 70-1 030612 PN=172