John Deere OMAL171363 (7430 and 7530) — Front Jaw Hitch

Additional Equipment Other Drawbar The drawbar is used to pull drawn equipment of all types, particularly PTO-driven implements. The drawbar is located to increase the rear axle load and slightly reduce load on the front axle. LX009842 —UN—02JAN95 Besides having a variable swinging range, the drawbar can also be adjusted lengthwise. Maximum permissible static vertical loads and towable loads are stated in the “Specifications” section. NOTE: Drawbar components that are subject to wear have to be checked every 250 hours (see “Service / Every 250 Hours”). Replace them if necessary. NOTE: Towing on public roads with the drawbar set to one side is not permitted!

OU12401,0001540 -19-09NOV06-1/1 Proper Use of Drawbar IMPORTANT: Comply with local traffic regulations when using the drawbar. Use suitable, approved hitch pins only. Combine drawbars as shown only. LX1036188 —UN—02MAY05 OU12401,0001205 -19-02MAY05-1/1 Adjustment of Drawbar The drawbar can be adjusted to three different lengths: 250 mm (9.8 in.), 350 mm (13.8 in.) and 400 mm (15.7 in.). These lengths determine the distance from the end of the PTO shaft to the attachment point of the drawbar. LX000460 —UN—09AUG94 1. Remove hex. plug (A). 2. Remove locking pin (B). 3. Move drawbar (C) to desired position and reinstall locking pin. 4. Tighten hex. plug (A) to 250 Nm (185 lb-ft).

OU12401,00015C2 -19-15DEC06-1/1 71-1 030612 PN=186