Additional Equipment Other Front Jaw Hitch A jaw hitch is integrated into basic weight (A) and the additional ballast weights (B). IMPORTANT: The jaw hitch should be used for shunting and towing on hard-surfaced roads only. LX1029234 —UN—03APR03 OU12401,00103E4 -19-01JAN03-1/1 Tow Hitch (Piton-Fix/Ball-Type) NOTE: Components of the piton-fix/ball-type tow hitch that are subject to wear have to be checked every 250 hours (see “Service / Every 250 Hours”). Replace, if necessary. LX1041424 —UN—10NOV06 Piton-fix tow hitch To attach an implement, pull up spring (A) and slide pin (B) to the right. Retainer (C) is forced upwards by a spring.
Once the implement is attached, push retainer (C) down and slide pin (B) all the way to the left. Move spring (A) back down to its locked position (the position shown in the illustration). A—Spring B—Pin C—Retainer OU12401,000153C -19-10AUG11-1/5 Ball-type tow hitch (old version) To attach an implement, push lock (A) to the front and slide pin (B) to the right. Retainer (C) is forced upwards by a spring. Once the implement is attached, push retainer (C) down and slide pin (B) to the left. Lock (A) springs back as soon as pin (B) reaches its locked position. If necessary, use an 8 mm (0.3 in.) hex. socket wrench to adjust the retainer set screw (D) to the eyelet of the trailed implement.
Then tighten the lock nut to 300 Nm (220 lb-ft) using a 30 mm (1.2 in.) wrench. LX1041425 —UN—19DEC06 A—Lock B—Pin C—Retainer D—Set Screw Continued on next page OU12401,000153C -19-10AUG11-2/5 71-2 030612 PN=187