John Deere OMAL171363 (7430 and 7530) — Handling and Storing Diesel Fuel

Fuel, Lubricants, Hydraulic Oil and Coolant Diesel Fuel Consult your local fuel distributor for properties of the diesel fuel available in your area. Sulfur content Diesel fuel quality and sulfur content must comply with existing emissions regulations for the area in which the engine operates. Use of diesel fuel with sulfur content less than 0.1% (1000 ppm) is STRONGLY recommended. Use of diesel fuel with sulfur content 0.2% (2000 ppm) to 0.5% (5000 ppm) results in REDUCED oil and filter service intervals. BEFORE using diesel fuel with sulfur content greater than 0.5% (5000 ppm), contact your John Deere dealer.

DO NOT use diesel fuel with sulfur content greater than 1.0% In general, diesel fuels are blended to satisfy the low temperature requirements of the geographical area in which they are marketed. Diesel fuels specified to EN 590 or ASTM D975 are recommended. Required fuel properties In all cases, the fuel shall meet the following properties: Cetane number of 45 minimum. Cetane number greater than 50 is preferred, especially for temperatures below -20°C (-4°F) or elevations above 1500 m (5000 ft). IMPORTANT: Do not mix used engine oil or any other type of lubricating oil with diesel fuel.

Cold Filter Plugging Point (CFPP) below the expected low temperature OR Cloud Point at least 5°C (9°F) below the expected low temperature. IMPORTANT: Improper fuel additive usage may cause damage on fuel injection equipment of diesel motors. Fuel lubricity should pass a minimum level of 3100 grams as measured by ASTM D6078 or maximum scar diameter of 0.45 mm as measured by ASTM D6079 or ISO 12156-1. OU12401,00013D9 -19-03APR06-1/1 Lubricity of Diesel Fuel Most diesel fuels manufactured in the United States, Canada, and the European Union have adequate lubricity to ensure proper operation and durability of fuel injection system components.

However, diesel fuels manufactured in some areas of the world may lack the necessary lubricity. If fuel of low or unknown lubricity is used, add John Deere Fuel-Protect Diesel Fuel Conditioner (or equivalent) at the specified concentration. Lubricity of Biodiesel Fuel IMPORTANT: Make sure the diesel fuel used in your machine demonstrates good lubricity characteristics. Fuel lubricity can improve significantly with biodiesel blends up to B20 (20% biodiesel). Further increase in lubricity is limited for biodiesel blends greater than B20. Fuel lubricity should pass a maximum scar diameter of 0.45 mm as measured by ASTM D6079 or ISO 12156-1. DX,FUEL5 -19-14APR11-1/1 80-1 030612 PN=198