Service / Every 250 Hours Check Oil Level in MFWD Axle Housing CAUTION: If the oil is hot, it may be under pressure. Unscrew the level plug slowly. Remove level plug (A). Oil must be level with screw bore. Fill to proper level, if necessary. Tighten level plug to 90 Nm (66 lb.-ft.). Always use a transmission oil listed in the Fuel, Lubricants, Hydraulic Oil and Coolant section. LX1029221 —UN—15APR03 NOTE: The position of the level plugs varies depending on axle type. OU12401,0000E02 -19-18MAY10-1/1 Check Oil Level in MFWD Final Drives CAUTION: If the oil is hot, it may be under pressure. Unscrew the level plug slowly. 1. Turn the wheel until OIL LEVEL mark (A) is horizontal.
LX1036518 —UN—26APR06 2. Remove level plug (B). Oil must be level with screw bore. 3. If necessary, top up with oil at this point. Tighten level plug to 90 Nm (66 lb.-ft.). Always use a transmission oil listed in the Fuel, Lubricants, Hydraulic Oil and Coolant section. NOTE: Change oil in axle housing and final drives after the first 100 hours of operation. Then change after every 1500 hours of operation or once every 2 years, whichever occurs first. OULXE59,0010830 -19-18MAY10-1/1 Check the Brakes Shut off the engine and check that the brakes are operating properly: 1. One at a time, press down on the left and right brake pedals. Do this several times to each pedal.
Distinct resistance should be noticeable at each of the two pedals. If no resistance can be felt at the pedals, get your John Deere dealer to bleed the air from the brakes. LX1031618 —UN—23JAN06 2. Check to make sure the pedals do not settle to the end of stroke within 10 seconds after being applied. If leakage exceeds this rate or if one pedal settles faster than the other, see your John Deere dealer. 3. Press both pedals down at the same time. Distinct resistance should occur at both pedals at roughly the same height. If the height at which resistance can be felt differs by more than 51 mm (2 in.), get your John Deere dealer to bleed the air from the brakes. IMPORTANT:
Any noticeable drift downward from the point of resistance indicates brake leakage. See your John Deere dealer. Distinct pedal resistance and balance between the left and right pedals are important for emergency braking with the two brakes coupled together. OU12401,00015CF -19-16DEC06-1/1 95-3 030612 PN=223