John Deere OMAL171363 (7430 and 7530) — Air Intake Hoses

Service / Every 500 Hours Changing the Fuel Filters Always change the two filters at the same time. 1. Disconnect cable (A) from the water sensor. 2. Unfasten filter retaining ring (B) and remove filter (C). Seal old filter with cover of the new one. LX1041439 —UN—20NOV06 3. Remove water separator and install it on new filter. 4. Attach new filter. The marks on the filter must be aligned with those on the housing. 5. Tighten retaining ring (B) until it clicks into place. 6. Reconnect cable (A). 7. Turn key in main switch to the right to the first switch position so that the fuel transfer pump is operating. Keep the pump running for approx. 40 seconds.

A—Cable B—Retaining ring C—Filter LX1041440 —UN—20NOV06 OU12401,000157C -19-18NOV06-1/1 Lubricating Rear Axle Bearings IMPORTANT: Carry out this service after every ten hours of operation when working under very wet and muddy conditions. Lubricate both bearings with six to eight strokes of John Deere multipurpose grease. LX000520 —UN—03JAN95 LX,OACH 000413 -19-01MAY92-1/1 Lubricate the Draft Link Bearings Lubricate grease fitting with several strokes of grease gun. Use John Deere multi-purpose grease. LX012558 —UN—27JUN96 OU12401,00015D3 -19-16DEC06-1/1 100-2 030612 PN=237