John Deere OMAL171363 (7430 and 7530) — Changing the Fuel Filters

Service / Every 500 Hours Changing Engine Oil IMPORTANT: Use oil with a viscosity suitable for the relevant season. NOTE: Carry out first oil change after first 100 hours of operation. LX1019669 —UN—17SEP99 Drain oil with engine shut off, but with engine oil still warm. 1. Remove drain screw (A). 2. While crankcase is draining, replace filter element. 3. Reinstall drain screw and tighten to 50 Nm (37 lb-ft). Use a new seal ring. 4. Fill crankcase with fresh oil of proper viscosity at filler neck (B). See section “Fuel, Lubricants, Hydraulic Oil and Coolant”. Capacity is approx. 19.5 liters (5.2 U.S.gal.). LX1041438 —UN—20NOV06 5. Check the oil level.

Oil should be up to the top mark on the dipstick. If necessary, top up with oil. 6. Run engine for a short time and check for leaks at filter base and drain screw. 7. Shut off the engine. 8. Check oil level once again. It must be up to the top mark on the dipstick. A—Oil drain screw B—Oil filler neck LX1041430 —UN—17NOV06 OU12401,00014D2 -19-18NOV06-1/1 Changing Engine Oil Filter Element Remove filter element (A) and clean mounting surface (B). If necessary, replace the dust seal on the contact surface with a new one. Make sure that the lugs on the dust seal engage in the recesses in the contact surface of the filter element.

LX1036524 —UN—19OCT05 LX1029276 —UN—08JUL02 Apply a thin film of oil to sealing rings (C) of new filter. Install new filter and tighten by hand. Start engine and check base of filter for leaks. Shut off engine and check oil level. NOTE: Carry out first oil filter change after first 100 hours of operation. OU12401,000132C -19-16OCT05-1/1 100-1 030612 PN=236