Service / Every 1500 Hours or 2 Years Changing Oil in Front-Wheel Drive Axle and Final Drives Change oil in axle housing and final drives after the first 100 hours of operation. Then change after every 1500 hours of operation or once every 2 years, whichever occurs first. Always use a transmission oil listed in the “Fuel, Lubricants, Hydraulic Oil and Coolant” section. Always drain oil while it is still warm, i.e. immediately after a prolonged period of operation. OULXE59,0010949 -19-18NOV07-1/1 Change Oil In Front-Wheel Drive Axle Housing CAUTION: If the oil is hot, it may be under pressure. Remove drain screw slowly. LX1029225 —UN—15APR03 1.
Remove drain screw (A) and drain oil into a suitable container. 2. Re-install drain screw and tighten to 90 Nm (66 lb.-ft.). 3. Remove oil level/filler plug (B). Fill with fresh oil. The oil level must be up to the filler hole. Re-install plug. For capacities, see Specifications. NOTE: Location of screws varies depending on axle type. LX1029226 —UN—15APR03 Hy-Gard is a trademark of Deere & Company OU12401,0000E07 -19-18MAY10-1/1 115-1 030612 PN=243 Recommended oil Hy-Gard™transmission/hydraulic oil. See also Section 80 (Fuel, Lubricants, Hydraulic Oil and Coolant). Capacity 8.2 L (2.2 US.gal.)