John Deere OMAL171363 (7430 and 7530) — Change Transmission/Hydraulic Oil (Tractors with AutoPowr)

Service / Every 1500 Hours or 2 Years Change Oil in Front-Wheel Drive Final Drives CAUTION: If the oil is hot, it may be under pressure. Remove drain screw slowly. 1. Turn wheel until drain screw (A) is at the bottom. Remove drain screw and drain oil into a suitable container. LX1036528 —UN—26APR06 2. Turn the wheel through 90° so that the line marked OIL LEVEL is horizontal (see Service / Every 250 Hours), and fill with fresh oil at drain screw bore. Oil must be level with screw bore. 3. Re-install drain screw and tighten to 90 Nm (66 lb.-ft.). Hy-Gard is a trademark of Deere & Company OU12401,00015D7 -19-18MAY10-1/1 Change Transmission/Hydraulic Oil (Tractors with AutoPowr) 1.

Start engine and operate several hydraulic functions to heat up oil. 2. Park tractor so that it is level. Lower draft links, front loader, front implements and other implements that draw oil from the transmission. LX1047177 —UN—11MAY09 3. Shut off engine and remove the key. 4. Engage park brake (transmission in park). 5. Remove drain screws (A). 6. Replace transmission/hydraulic oil filter element (B). 7. Remove oil line (C) and screw-plug (D). Pull out intake screens and wash them in fuel. Clean the area where the intake screens are installed. Re-install the intake screens. LX1047178 —UN—11MAY09 8. Before refilling with fresh oil, replace seals and tighten drain screws to 50 Nm (35 lb-ft).

9. Add transmission/hydraulic oil to the transmission case. For capacities, see Specifications. Run engine briefly and operate hydraulic functions. Shut off engine. Wait for between 10 and 15 minutes before checking the oil level. It should be between the marks on the sight-glass. If not, correct oil level. A—Drain screws B—Transmission/hydraulic oil filter C—Oil line D—Screw-plug OU12401,0001CF4 -19-03OCT09-1/1 115-2 030612 PN=244 Recommended oil Hy-Gard™transmission/hydraulic oil. See also Section 80 (Fuel, Lubricants, Hydraulic Oil and Coolant). Capacity (axle without brake) 1.7 L (0.4 US.gal.) Capacity (axle with brake) 2.6 L (0.7 US.gal.)