John Deere OMAL171363 (7430 and 7530) — Changing the Oil at the Front PTO (If Equipped)

Service / Every 1500 Hours or 2 Years Change Transmission/Hydraulic Oil (Tractors not equipped with AutoPowr) 1. Start engine and operate several hydraulic functions to heat up oil. 2. Park tractor so that it is level. Lower draft links, front loader, front implements and other implements that draw oil from the transmission. RW20384 —UN—28JUL92 3. Shut off engine and remove the key. 4. Apply the park brake (transmission in neutral). 5. Remove drain screws (A). 6. Change transmission/hydraulic oil filter. See Service / Every 750 Hours. 7. Pull out intake screen and wash it in fuel (see next block). 8. Before refilling with fresh oil, replace seals and tighten drain screws to 50 Nm (35 lb-ft).

RW55745 —UN—08JUL96 9. Add transmission/hydraulic oil to the transmission case. For capacities, see Specifications. Run engine briefly and operate hydraulic functions. Shut off engine. Wait for between 10 and 15 minutes before checking the oil level. It should be between the marks on the sight-glass. If not, correct oil level. OU12401,0001CF5 -19-03OCT09-1/2 Clean the intake screen As soon as you have drained the transmission/hydraulic oil, remove oil line (A) at the front left of the differential housing. Take out the intake screen, wash it in fuel and then clean it with compressed air. Clean the area where the screen is installed.

RW55746 —UN—11JUL96 Re-insert the screen, and re-install the seal, O-ring and oil line. OU12401,0001CF5 -19-03OCT09-2/2 115-3 030612 PN=245