Service / Every 6000 Hours Change the Coolant CAUTION: Do not open cap (A) of expansion tank before coolant temperature is below boiling point. First loosen the cap to relieve pressure, then remove cap completely. LX1036534 —UN—20OCT05 LX1036579 —UN—10JUN05 NOTE: If COOL-GARD is not used, the drain interval is reduced to 2 years or 2000 hours of operation. 1. On tractors with cab, turn the heater control as far as it will go to the right. 2. First loosen cap (A) and then take it off. 3. Turn connect/disconnect control (B) anti-clockwise as far as it will go. 4. Place a container under the drains to trap the coolant as it emerges. Open drain plug (C).
As soon as system is empty, close drain plug (C) and fill the system with clean water. LX1036535 —UN—20OCT05 LX1038337 —UN—27APR06 IMPORTANT: Never pour cold water or coolant into the hot engine. Always use warm water or wait until engine has cooled down. CAUTION: Before starting the engine, always close the hood. Run the engine until it reaches operating temperature. Shut off engine and drain cooling system. A—Filler cap B—Connect/disconnect control (front of radiator) C—Drain plug (rear of radiator) D—Lines Close drain plug again and fill the system with clean water. Again run engine until it has reached operating temperature. Shut off engine and drain system again.
Start the engine and bring it up to operating temperature. Shut down the engine and add coolant up to the max. mark on both tanks. Close the drain plug and disconnect line (D). Fill the system with the prescribed coolant (see Fuel, Lubricants, Hydraulic Oil and Coolant section) until coolant emerges from line (D). Retighten line (D). Turn connect/disconnect control (B) clockwise as far as it will go. Add coolant up to the max. mark on both tanks. Re-install and close the filler cap (A). Start the engine and run it for 5 minutes. For efficient cooling, the radiator screen must be kept clean. Remove any dust or oil and carefully straighten any bent fins.
Shut down the engine and add coolant up to the max. mark on both tanks. OU12401,0001C84 -19-16OCT09-1/1 120-2 030612 PN=248