Operator's Cab Routing the cables The rear window of the cab is provided with two openings, allowing the cables to be routed. Open the window and take out the rubber stoppers. Cut the rubber stoppers at the incisions provided to enable the cables to be routed. Connect the connectors, insert the rubber stoppers and close the window. LX1026097 —UN—09MAR01 OU12401,0001B92 -19-24AUG10-2/2 Multiple Power-Outlet Socket Strip (If Equipped) A strip of extra sockets may be installed on the front of the switch console. Terminal A on the socket strip is protected by a 30-amp fuse. Terminal C is protected by a 10-amp fuse, and terminal B is ground.
LX1036247 —UN—24APR06 Turn key in main (key) switch to the right to supply power to terminal C. Terminal A is supplied with power even when the ignition is switched off. IMPORTANT: Electrical equipment requiring high current inputs may be operated, and the use of multiple power outlets is permitted, but the supply circuit must never be overloaded. Remember, total load comprises the sum of all the current consumers connected to the on-board circuit at any one time. This also applies if the consumers are connected to the on-board circuit at different sockets. OU12401,0001B93 -19-24AUG10-1/1 Service ADVISOR™Socket This socket is suitable only for service and diagnostic purposes.
Do not connect any other equipment. LX1036248 —UN—03JUN05 SERVICE ADVISOR is a trademark of Deere & Company OU12401,000122A -19-24MAY05-1/1 25-17 030612 PN=70