Operating the Tractor — PowrQuad Plus Shift the PowrQuad Plus Transmission Gears are shifted using range shift lever (A), gear-shift buttons (B) - or switch (E) - and reverser lever (C). The hand clutch is operated via button (D). Before starting the engine, move reverser lever (C) to neutral position. To drive, first move range-shift lever (A) to the desired range and then move the reverser lever to the desired direction of travel. LX1044955 —UN—09JAN08 CAUTION: If the reverser lever is actuated when the engine is running and a range is selected, the tractor will start to move. To change the ranges, the clutch pedal must be depressed or the hand clutch button must be actuated.
There is no need to actuate the clutch to shift gears or to change the direction of travel. To park the tractor, move reverser lever (C) to neutral and engage park at range-shift lever (A). LX1044439 —UN—11DEC07 IMPORTANT: Engage park only when the tractor is stationary. NOTE: If shift lever (A) is moved to park when reverser lever (C) is not in neutral, an audible alarm is triggered and the blue light comes on. When the engine is shut off, the reverser lever remains in its selected position but the transmission shifts into neutral.
Range-shift lever and buttons (with hand clutch) If the reverser lever is not in neutral when the engine is started, an audible alarm is triggered and the relevant message appears on the CommandCenter to alert the operator. LX1036266 —UN—06JUN06 If the reverser lever is moved out of neutral while park is engaged, an audible alarm is triggered and the blue light comes on. To make the tractor move, first put the reverser lever in neutral and then move it to the desired position. Hand clutch (if equipped) Press button (D), the clutch separates. Ranges may be selected or the tractor can be halted. Release button (D), the clutch engages with modulation.
On tractors equipped with a seat switch (operator presence switch), the following applies: If, within the last 3 seconds before the button is released, there was no weight on the seat and no actuation of the clutch pedal or brake pedal, the tractor does not move, even although the reverser lever is in the forward or reverse position. A message appears on the CommandCenter. To make the tractor move, move the reverser lever to neutral and then back into the desired direction. LX1044922 —UN—11DEC07 NOTE: The hand clutch is not suitable for “creeping” up to an implement.
A—Range-shift lever B—Gear-shift buttons C—Reverser lever D—Hand clutch button E—Gear shift switch (extra) Continued on next page OU12401,00019B1 -19-18APR08-1/2 46-1 030612 PN=96