John Deere OMAL171363 (7430 and 7530) — PowrQuad Plus Transmission — Settings

Operating the Tractor PowrQuad Plus The hand clutch can be activated and de-activated at address EPC167. See “Customization” in the “Diagnostic Trouble Codes and Customization” section. move. When the oil has had time to warm up, operation becomes normal again. Optimum gear-shifting for driving under load (transport): "Come-home" mode Under certain circumstances, the tractor can still be driven in “come-home” mode even if there is an electrical fault in the transmission. 1. Select a range suitable for driving under load. 2. Engage the first gear. 3. Drive and shift up through the ranges until the top range is reached. 4. Shift up through the gears.

To do this, stop the engine, remove plug K07/4 (relay box K07) and re-install it at a position 90° from its original position. The wording “Come Home” must be at the top. NOTE: In the come-home mode, engine speed is limited to 1500 rpm and only the first gear in each range is available. The hand clutch is NOT available. Cold-weather operation If the oil is cold (0°C, 32°F), it may affect how the reverser lever operates. At temperatures below -10°C (14°F), it may take longer to change the direction of travel. Below +5°C (41°F), the automatic engine-speed matching is de-activated.

Restriction in the event of a missing speed signal If the control unit notices that the speed signal is missing, only the first three gears in each range are available. In certain circumstances, the reverser lever may have to be actuated several times before the tractor starts to OU12401,00019B1 -19-18APR08-2/2 PowrQuad Plus Transmission — Settings Speed-matching when changing ranges If this option is activated, when changing ranges at travel speeds at or above approx. 7 km/h (4.4 mph), the transmission is automatically shifted into a gear that matches the travel speed. This automatic function can be overridden by holding down one of the gear shift buttons.

LX1037622 —UN—06NOV06 Press transmission button (A) and select speed-matching (B). Engine-speed matching when shifting gears If this option is activated, engine speed is altered temporarily by the electronics to achieve a smoother shift. Press transmission button (A) and select engine-speed matching (C) and - if desired - PTO operation (D). Engine speed can then be matched in the following ways:

Switched off all the time, if (C) is not activated Switched on, but off for PTO operation if only (C) is activated Switched on all the time, if (C) and (D) are activated LX1044925 —UN—11DEC07 Initial gear (at start-up) The figure in cell (E) determines which gear will be automatically selected at the transmission immediately after the engine is started. A—Transmission button B—Speed-matching C—Engine-speed matching D—PTO operation E—Initial gear (at start-up) Continued on next page OU12401,000196F -19-23DEC07-1/2 46-2 030612 PN=97