4 4 Brakes – 4.1 Controls and instrumentation 4.1 Controls and instrumentation 4.1.1 Brake pedal page Brake pedal, checking and adjusting 1 Clean the floor around the brake pedal and check that nothing blocks movement of the brake pedal. 2 Check that the brake pedal springs back sufficiently and that the clearance between brake pedal and brake valve is 1–1.5 mm. If needed, adjust the brake pedal's set screw to obtain the correct clearance. 3 Check that the pedal's travel is smooth. Set screw for adjusting clearance between brake pedal and brake valve. (Illustration shows loose brake pedal.) 4 Grease the pedal hinges with universal grease "EP2".
5 Check that the rubber on the pedal is intact and that the tread pattern isn't worn out. Change if necessary. Lubrication points, brake pedal. (Illustration shows loose brake pedal.) UDRF01.04GB Maintenance manual DRF 400–450