4 Brakes – 4.3 Service brake system 5 4.3 Service brake system page Power-assisted brake system, function description The power-assisted brake system consists of a brake oil tank, brake oil pump, brake oil filter, accumulator charging valve, accumulators, brake valve, pressure sensors, brake cylinder and wheel brake units. The brake oil pump pumps oil (from tank) which is cleaned in the oil filter. The accumulator charging valve directs pressure to the accu- mulators that store pressure or direct the oil through the wheel brake for cooling of the brake discs. The brake valve directs pressure from the accumulators to the brake cylinder.
The brake cylinder compresses the discs in the brake units that brake the machine. Make-contact brake pressure gives a signal so that the brake lights are activated when the brake cylinder is pressurized. When the accumulators are charged, the accumulator charging valve controls oil through the drive axle's brake units and cools the brakes. The oil passes through the cooler back to the tank. An elec- tric cooling fan increases the air flow through the cooler when the temperature needs to be lowered. A thermal by-pass valve leads the oil past the cooler if the oil's temperature is low. The temperature sensor controls activation of fan and temperature warning on the display.
UDRF01.04GB Maintenance manual DRF 400–450