Kaiyi UDRF01.04GB — 6.2.3 Wheel hub

6 6 Suspension – 6.2.3 Wheel hub 5 Torque the bearing nut as follows. A. Lubricate the thread on the spindle and the side of the nut facing the bearing with oil SAE 80W/140. B. Tighten the nut to 250 Nm. C. Rotate the hub at least 2 revolutions and then tighten the nut 45 degrees. D. Rotate the hub again at least 2 revolutions and then tighten the nut another 45 degrees. 6 Fit the lock washer and outer lock nut. 7 Tighten with at least 250 Nm or as hard as is needed to bend the lock washer in the closest groove. 8 Fill the bearing casing with grease and fit it. 9 Grease the wheel bearing with grease through the grease nip- ple.

Lift the seal ring's lip with a small screwdriver to facilitate the air to escape. Grease until grease comes out by the seal. NOTE Work carefully so as not to damage the seal. UDRF01.04GB Maintenance manual DRF 400–450