14 6 Suspension – 6.3 Tyre and rim system 2 Fit the inner spacer ring. NOTE The inner ring is not split. 3 Lift the outer wheel into place with lifting equipment. Rotate the wheel so that the guide lug enters the groove on the hub. 4 Fit the outer spacer ring. NOTE The outer ring is split. Rotate the ring so that the opening ends up in front of the groove on the hub. 5 Place clamps and nuts on the wheel bolts. Where applicable, also washers. NOTE Do not forget the retainer for the inner tyre's valve exten- sion. 6 Remove the lifting equipment. 7 Tighten the wheel nuts crosswise. 8 Tighten the wheel nuts crosswise with torque 400 Nm . UDRF01.04GB Maintenance manual DRF 400–450