Kaiyi UDRF01.04GB — 6.3.2 Rims

18 6 Suspension – 6.3.2 Rims page Tyres, changing DANGER Changing tyres is complicated and dangerous work. FATAL DANGER! Leave tyre work to authorized personnel/ tyre com- pany. 6.3.2 Rims page Rim, checking DANGER Perform the following checks to minimize risks of accidents for all rims that can be dismantled. Always use the correct size of tyre and a design that is compatible with the type and size of the rim. Over-dimensioned tyres must not be used. Replace all damaged, worn or corroded rims or mounting parts. 1 Dismantle the rim, see Tyres, changing page 18 . 2 Carefully clean the outside of the rim edge with a steel brush. 001703 001715 3 Measure wear after the lock ring.

The lock ring's wear on the rim edge often leaves a mark, A in the figure. The mark shows up between the ends of the lock ring. Measure depth of the wear at point A with a steel ruler and sliding calipers. If wear exceeds 0.5 mm, the rim, lock ring and the rim bead seat taper must be discarded and replaced with new parts. A Max 0,5 mm UDRF01.04GB Maintenance manual DRF 400–450