6 Suspension – 6.3.2 Rims 19 4 Check the rim's diameter. Measure the rim edge's circumference (O) with a measuring tape and calculate the diameter (D). [D = Circumference (O) / 3.14] Compare the value of the diameter with the specified min. measurement. If the diameter is smaller, the rim, lock ring and the rim bead seat taper must be discarded and replaced with new parts. D O Information about min. diameter can be obtained from Kalmar Industries. 001701 O. Circumference D. Diameter 5 Check for damage in the areas with high stress concentration. Checking is done in two steps: 1. The magnetic powder method is used to determine if there's a crack or not, and where it is. 2.
Confirmed cracks are investigated further with penetrating fluid. Typical rim damages are circumference cracks, corrosive dam- age, rust, warping and wear. 001702 001703 Magnetic powder method 1 Blast clean the marked area around the entire rim so that it is completely clean from all paint. 2 Test using magnetic powder and the following equipment: Equipment: Yoke Tiede Method: a. AC current b. Contrast fluid Checking medium: a. Wet b. Fluid (e.g. Tiede Ferrolux) If no cracks are detected with the magnetic powder method, checking is finished and the rim is approved. If cracks are indicated, the crack should be investigated further with penetrating fluid.
UDRF01.04GB Maintenance manual DRF 400–450