8 7 Load handling – 7.2.2 Servo filter 4 Clean the outside of the filter housing and filter holder. 5 Remove the filter holder and remove the cartridge downward. 6 Clean the inside of the filter holder. 7 Place the new cartridge in the filter holder. 8 Check that the O-ring on the filter holder is intact and in place. 9 Fit the filter and filter holder. 10 Check the hydraulic oil level with the lift cylinders completely down and the extension cylinder completely in. The oil level should be at the top of the level glass. Top up as needed, for grade see section F Technical data . NOTE The hydraulic oil level is checked with the boom complete- ly lowered and retracted.
UDRF01.04GB Maintenance manual DRF 400–450