Kaiyi UDRF01.04GB — 7.5.7 Positioning chains

7 Load handling – 7.5.7 Positioning chains 25 10 Start the engine and run in the spreading to the 40-foot posi- tion. 9 If needed, adjust the 40-foot stops. 11 Wait 2 minutes and then check the tension of the chains. Measure how much the chain can be pushed in at the hole clos- est to the centre of the attachment. When the chain is pressed in with a force of 250 N it should move 20–40 mm from resting position. 12 If needed, adjust the tension of the chains. Start the engine and run out the spreading until the chain ten- sioner is visible in the inspection hole. Adjust the chains. NOTE 005106 Adjust the chain max. 2 mm at a time on the chain tension- er.

13 Repeat steps 9–11 until the chain tension is correct. 14 If the machine is equipped with 30-foot or 35-foot stops: Start the engine and run out the spreading to the 30-foot or 35-foot position. Turn off the engine and check the C-C measurement between the twistlocks. C-C 30-foot: 8918 ± 3 mm C-C 35-foot: 10488 ± 3 mm IMPORTANT Check the distance at stop from both 20' and 40'. 15 Brush lubrication grease on the spreader chain. 16 Fit the cover plates to the attachment's main beam. UDRF01.04GB Maintenance manual DRF 400–450