7 Load handling – 7.9.1.7 Twistlocks 43 6. Control unit cab (D790-1) 13. Lock cylinder 7. Control unit frame rear (D797-R) 14. Sensor unlocked twistlocks (B7204) or Sensor locked twistlocks (B7205) Hydraulic diagram top lift Hydraulic diagram top lift, tilt lock and controllable tilt Hydraulic diagram combi attachment Hydraulic diagram top lift, tilt lock, controllable tilt and hydraulic lev- elling page Twistlocks, component position Hydraulic oil pump, Shuttle valve See Lift and lower, component position page 6 .
Valve block top lift hydraulics, Control valve attach- ment, Lock cylinder twistlocks, Twistlocks, Sensor alignment, Sensor twistlocks, relief valve attach- ment See Sideshift, component position page 15 . 7.9.1.7 Twistlocks page Twistlocks, checking 1 WARNING Make sure that the engine is off when working on the twistlocks. 2 Twistlocks can be locked automatically if all sensors for alignment are activated manually. 5 1 Check that the twistlocks function correctly. Lock and open the twistlocks, check that the indicator lights work, both in cab and on boom. 4 3 2 Clean the twistlocks from any dirt. 3 Under the rubber cover for twistlocks: check pin, link arm and lock nut.
4 Clean the area around the sensor for alignment. 5 Press in the alignment pin so that the head is flush with the spreader beam's underside. Check the distance to sensor align- ment, distance should be 5 ± 1 mm . Adjust as needed 000536 1. Lock mechanism 2. Sensor alignment 3. Alignment pin 4. Lift pin 5. Lock guide NOTE The alignment pin should move easily and spring back completely. UDRF01.04GB Maintenance manual DRF 400–450